Is it very hard to install a new liner for an Above Ground Pool?

We have a 15ft x 30ft x 4ft pool. We have it drained and have the new liner. We were told that with 4 or 5 guys it wouldn't be a big deal to install it ourselves. The company wants $600. to install it for us. Any advice on do's or don'ts?

Replacing the liner is an easy job, just have several people to help. Don't replace it on a cold or cool day Do replace it on a warm sunny day. The heat from the sun will allow the vinyl to stretch a little into place especially when you are refilling the pool. Check to see what caused the old liner to rupture. Sticks stones what ever. If the old liner is still in the pool and still in good shape except for the hole that let it leak leave it in place. I always left it in place and put the new one over the top of it letting the old one be a protective barrier for the new one. When you go to open the new liner place it in the middle and open it outwards and rearrange it to fit generally in the bottom of the pool area. I am assuming you have already taken the top rail that holds the liner to the outer wall off, If not now’s the time Along with the through pool fittings such as the strainer and the return port. Start some place by placing the liner over the support wall and have some one hold it from slipping off. Work your way along the pool wall several feet and as you go take spring loaded close pins and hold the liner in place as you hang it. Pull the seam of the liner to the base of the support wall have every one pull the liner so you don't tear or stretch it out of shape. As the liner is hung on the support wall have some one get into the liner with stocking feet and help you hang the liner using the cloths pins, every one else helps unfold and adjust the liner. When your about half way done look to see if the seam of the liner is running along the base of the pool if not adjust the remaining liner so it is close. Keep going around the pool till you get back to your starting point. Look and adjust the liner as needed. When your satisfied that the liner is in properly and most of the wrinkles are out you can start adding water but again do it on a sunny warm day so it will slowly stretch and take shape. When you have about an inch of water in the pool carefully work out any wrinkles by grasping the vinyl ahead of the wrinkle in the direction you want to go and pull you will form another wrinkle in front of the old one . Repeat this till you get to the wall and have pulled out the wrinkles. Several people can do this at one time it goes quick. Once the wrinkles are gone start to fill the pull a little more, the pool should start to take shape with a couple inches of water, here is where you want to hold the vinyl against the filter opening and cut the new hole for those through pool fittings. Remember always cut from the center of the hole to a corner or side forming a cross or an x for the first 4 cuts then cut each one again if necessary but 4 should do it. Pull the little triangle tabs of vinyl through the opening and tape against the backside of the pool support wall to hold in place then replace the fittings with their screw s or compression flanges and gaskets. Once the through pool fittings are back in place hook up the hoses and fill the pool. Once the pool is filled and water is circulating take a sample to the pool store tell them you just filled the pool and need to know what to put in it and how much. Also if you are a city dweller contact the water company and tell them you are going to fill your pool and they will give you a discount on your sewerage rate because the water is not going to be flushed or drained into the sewer system, since the water is going into the pool and will stay there they will not charge you for treating the water as sewerage. Hope this helps good luck

For More Information on Pool Liner Above Continue On Below-

-Watch A Pool Liner Above Video-

Swimming Pool Liner Failure

Pool Liner Above Article

Types of Above Ground Pool Liners

When the good old summertime rolls around, it's time to get the swimming pool ready. The people who have a swimming pool in

their own backyard should be thankful. They can go swimming to help combat that burning sensation of the sun rays. There are

two different types of swimming pools that are available for home use, the above ground swimming pools and the in ground

swimming pools, the above ground swimming pools are considerable less expensive. While many people take a lot of care to

protect their swimming pools, they usually forget one thing and that is the installation of pool liners.

It doesn't matter if the swimming pool is regularly used or not, their base and walls will get covered with mold. Aside from

the mold, the base and walls of the swimming pool may also get damaged from daily use. Pool liners are designed to extend the

life and protect your pool by covering its base and walls. Usually, pool liners are made from synthetic materials such as

highly resilient vinyl.

The best time to install pool liners is when the swimming pool is being installed. The installation of the swimming pool and

the installation of pool liners are done by securing the pool liners with the assistance of some fittings that are located

along the edges of the swimming pool.

In addition, pool liners may also be installed with the assistance of water resistant and synthetic adhesives. Adhesives work

great because the entire surface of the pool liners is adhered. But, don't expect pool liners to last as long as the swimming

pool because they need to be replaced after a few years. The amount of time before replacement is determined by how much the

swimming pool is used and the climate where the swimming pool is located. You can find pool liners on the Internet, however,

it is a good idea to buy pool liners from the store that you bought the swimming pool from.

Rather than waiting until later, you need to order pool liners with the swimming pool, because it is better to have pool

liners installed at the same time as the swimming pool is installed. The primary advantage of attaching pool liners is that

they help to protect the bottom and sides of the swimming pool and they are easy to wipe clean. If you are going to install

pool liners yourself and you intend on using the adhesive method, you need to make sure that there are no air bubbles trapped

between the pool and the pool liners.

About the Author

Click here for more information about pool liners and above Ground Pool Liner

All of us hope the content and web links we have presented for Pool Liner Above has been a beneficial help. If not, dont forget to browse additionally
through our web page to discover a lot more concerning Pool Liner Above

Search For More Pool Liner Above

by using the search box or links on the side of the page. Thanks